Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » honda fury gas tank removal
Viewing all articles
Browse latest Browse all 10

Ford F-Series Fuel Tank Installation Instructions

0
0

Since 1948, Ford F-Series vans have been a dependable part of the American driving experience. A roomy flat mattress to hold your furnishings and the rest it is advisable to travel with. Putting in a fuel tank in a Ford F-Sequence model is the same in all Fords, except the Bronco. Understand how your F-Series runs earlier than going additional within the set up process.

Ford F-Series Fuel Tank Installation Instructions

1. Take off the fuel tank filler cap and deactivate the automotive battery by unplugging the battery ground cables. Insert a siphoning hose to empty the gas right into a fuel container. Lift the truck on jack stands to get underneath the truck. Remove the fuel strains and hoses on or around the fuel tank. Unwrap the tank straps from each end of the tank. Loosen the strap bolts with a torque wrench. Decrease the tank to the bottom with a ground jack and a picket board for support.
2. Look at your fuel tank for any cracks or corrosion before getting a replacement fuel tank from any auto supply store. Use a flooring jack to lift the fuel tank to the entrance middle of the Ford’s flat mattress on all F-series models. Connect the tank strap bolt on each tank side together with the tank straps. Adjust the setting on the tank strap bolts to 18 ft-lb with a torque wrench.
3. Install your fuel gauge sending unit again to the highest of the tank. Be sure that to connect the unique tank’s gauge sending unit in the event you’re replacing the fuel tank completely. Mount the tank closer to your truck by wrapping the top and bottom tank mounting straps around your gas tank.
4. Activate the fuel line push-connect fittings on top of the gas gauge sending unit to course of the gas inside your tank. Put the filler neck hose on the right facet of the tank. Also tighten the filler neck hose clamp on the high of the filler neck hose.
5. Plug the gas gauge sending unit wire on high of the tank. Cowl the tank with the skid plates and warmth shields to guard the tank from attainable damage. Activate the automobile battery by plugging within the battery floor cables. Replenish your tank with fuel to be able to take a look at drive it. Restore gas stress by protecting the tank with the fuel tank filler cap.
6. Check underneath your Ford truck for any attainable fuel leaks. Take a look at the wiring on or around the fuel tank to make sure none of it is loose. If all the things is in working, start your automobile to see how the engine runs. Take your automobile for a spin when you verify your truck is fine.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images